Toyota 4Runner: Components

Washer Level Warning Switch

...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Other materials about Toyota 4Runner:

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DOME RELAY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR (a) Turn the ignition switch off. (b) Disconnect the cable from the negative (-) battery terminal. CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) bat ...