Toyota 4Runner manuals

Toyota 4Runner: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / DTC.

(e) Read the DTCs.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / (desired system) / DTC.

(e) Clear the DTCs.

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any p ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Front Power Seat Control System DTC Code Detection Item See page B2650 Slide Sensor Malfunction ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. When installing the window frame moulding, heat the vehicle body and window frame moulding using a ...

Brake Signal Malfunction (B2284)
DESCRIPTION This DTC is stored when the brake signal information from the cable and the brake signal information from the CAN communication line are inconsistent HINT: When the power management control ECU is replaced with a new one and the cable is con ...

© 2016-2025 | www.to4runner.net

0.0069