INSTALLATION
PROCEDURE
1. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
(a) Attach the claws of the No. 2 parking brake cable.
(b) Install the No. 2 parking brake cable assembly to the parking brake equalizer with the clip.
(c) Install the No. 2 parking brake cable assembly with the 5 bolts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(d) Install the No. 1 parking brake cable heat insulator.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(e) Install the No. 2 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Attach the claws of the No. 3 parking brake cable.
(b) Install the No. 3 parking brake cable assembly to the parking brake equalizer with the clip.
(c) Install the No. 3 parking brake cable assembly with the 4 bolts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(d) Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
3. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER
HINT:
Refer to the procedures from "Install No. 2 Parking Brake Shoe Assembly with
Parking Brake Shoe Lever" (See page ).
4. INSTALL FUEL TANK SUB-ASSEMBLY
(a) Install the fuel tank sub-assembly (See page
).
5. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL
6. INSTALL REAR CONSOLE BOX ASSEMBLY
(a) Install the rear console box assembly (See page
).
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Read the DTCs.
2. CLEAR DTC
(a ...
Diagnosis System
DIAGNOSIS SYSTEM
DESCRIPTION
(a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector
3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning,
use the Techstream to check for malfunctions and to perform r ...