Toyota 4Runner manuals

Toyota 4Runner: Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / Portable Player cannot be Operated Using In-vehicle Device or Track Information is not Displayed on In-vehicle Device

PROCEDURE

1.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check if track information is displayed normally on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Track information is displayed normally.


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

PORTABLE PLAYER IS NOT COMPATIBLE

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT HINT: Perform this check with the portable player volume set at an appropriate level. Make sure that there are no obstructions between the portable player ...

Other materials about Toyota 4Runner:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the h1 multiplex network master switch connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wi ...

Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Temporarily install the set bolt. (b) Install the hydraulic brake booster (See page ). (c) tighten the brake pedal support sub-assembly with the 4 nuts. Torque: 14 N·m {145 kgf·cm, ...

© 2016-2020 | www.to4runner.net

0.0034