Toyota 4Runner manuals

Toyota 4Runner: Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK DTC

HINT:

When DTC B1650/32 is stored as a result of troubleshooting for the airbag system, perform troubleshooting for the occupant classification system.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes.

(e) Check the DTCs by following the prompts on the screen.

HINT:

Refer to the Techstream operator's manual for further details.

2. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Occupant Detection / Trouble Codes.

(e) Clear the DTCs by following the prompts on the screen.

HINT:

Refer to the Techstream operator's manual for further details.

Diagnosis System
DIAGNOSIS SYSTEM 1. SYMPTOM SIMULATION HINT: The most difficult case in troubleshooting is when no problem symptoms occur. In such a case, a thorough problem analysis must be carried out. A simul ...

Occupant Classification ECU Malfunction (B1795)
DESCRIPTION DTC B1795 is stored when a malfunction is detected in the occupant classification ECU. Troubleshoot DTC B1771 first when both DTCs B1771 and B1795 are present. DTC Code ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after d ...

Installation
INSTALLATION PROCEDURE 1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Temporarily install the set bolt. (b) Install the brake booster assembly (See page ). (c) Install the brake master cylinder sub-assembly (See page ). (d) Install the brake pedal suppo ...

© 2016-2025 | www.to4runner.net

0.0285