Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL STEREO COMPONENT TUNER ASSEMBLY
(a) Connect the 6 connectors to the radio and display receiver assembly or navigation receiver assembly and stereo component tuner assembly.
HINT:
Connect the connectors with white tape to the radio and display receiver assembly or navigation receiver assembly.
2. INSTALL NO. 2 RADIO BRACKET
.gif)
3. INSTALL NO. 1 RADIO BRACKET
4. INSTALL HAZARD SWITCH WIRE
5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)
7. INSTALL HEATER CONTROL ASSEMBLY
8. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
9. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
11. CHECK SRS WARNING LIGHT
(See page )
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(See page )
2. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
3. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNIS ...
Other materials about Toyota 4Runner:
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Check the details of the DTC(s)
...
Unable to Lock Steering Wheel
DESCRIPTION
The steering lock ECU sends an unlock position signal to the power management
control ECU. Upon receiving the signal, the power management control ECU permits
an engine start. This prevents the engine from being started with the steering locke ...
0.0066