Toyota 4Runner: No Sound can be Heard from Speakers

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / No Sound can be Heard from Speakers

PROCEDURE

1.	CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs

PROCEDURE 1. NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source ca ...

Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat) 2. REMOVE QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat) 3. REMOVE REAR DOOR SCUFF PLATE RH 4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH 5. REMOVE NO. 1 LUGGAGE COM ...

Inspection
INSPECTION PROCEDURE 1. INSPECT SPIRAL CABLE SUB-ASSEMBLY (a) If there are any defects as mentioned below, replace the spiral cable with a new one: Scratches, cracks, dents or chips in the connector or spiral cable. (b) Check the spiral cable. Text in ...