Toyota 4Runner manuals

Toyota 4Runner: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.

CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that the mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.


OK

END

NG

2.

CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.


OK

END

NG

3.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.


OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE


NG

MALFUNCTION IN PORTABLE PLAYER

Cellular Phone Inspection
PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Other materials about Toyota 4Runner:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). 2. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLO ...

Inspection
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Front Wiper Switch Tester Connection Switch ...

© 2016-2025 | www.to4runner.net

0.0257