SYSTEM DESCRIPTION
1. GENERAL
This system has the following functions: manual slide open and close, auto slide open and close, manual tilt up and down, auto tilt up and down, jam protection, key off operation, key-linked operation and wireless transmitter-linked operation.
HINT:
If the driver side door is opened with the ignition switch off and the sliding roof open, the buzzer sounds.
2. FUNCTION OF MAIN COMPONENT
|
Component |
Outline |
|---|---|
|
Sliding roof drive gear sub-assembly (Sliding roof ECU) |
The sliding roof ECU controls the rotational direction of the motor, which tilts or slides the sliding roof glass. |
|
Map light assembly (Sliding roof switch) |
The sliding roof switch outputs operation signals to the sliding roof ECU. |
3. SYSTEM OPERATION
The sliding roof has the following features.
|
Function |
Outline |
|---|---|
|
Manual slide open and close |
|
|
Manual tilt up and down |
|
|
Auto slide open and close |
This function causes the sliding roof to be fully opened (or closed) when the slide open switch (or slide close switch) is pressed for 0.3 seconds or more. |
|
Auto tilt up and down |
This function causes the sliding roof to be fully tilted up (or tilted down) when the tilt up switch (or tilt down switch) is pressed for 0.3 seconds or more. |
|
Jam protection function |
The jam protection function automatically stops the sliding roof and moves it open halfway (or fully tilts it up) if a foreign object gets jammed in the sliding roof during close or tilt down operation. |
|
Key-off operation |
The key-off operation function makes it possible to operate the sliding roof for approximately 43 seconds after the ignition switch is turned off if the driver side door is not opened. |
|
Wireless transmitter-linked operation |
HINT: This function is linked with the power window wireless transmitter-linked operation. |
|
Key-linked operation |
HINT: This function is linked with the power window key-linked operation. |
|
Sliding roof open warning |
When the ignition switch is turned from ON to off and the driver door is opened with the sliding roof open, the buzzer in the combination meter assembly sounds once. |
System Diagram
How To Proceed With TroubleshootingInstallation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt
chart (See page ).
PROC ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the T ...