Toyota 4Runner: TRAC OFF Indicator Light does not Come ON

Toyota 4Runner Service Manual / Brake / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / TRAC OFF Indicator Light does not Come ON

DESCRIPTION

Refer to TRAC OFF Indicator Light Remains ON (See page ).

WIRING DIAGRAM

Refer to TRAC OFF Indicator Light Remains ON (See page ).

CAUTION / NOTICE / HINT

NOTICE:

When replacing the master cylinder solenoid, perform calibration (See page ).

PROCEDURE

1.	CHECK CAN COMMUNICATION LINE

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.	INSPECT VSC OFF SWITCH

REPLACE VSC OFF SWITCH

3.	CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH)

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.	READ VALUE USING TECHSTREAM (TRAC/VSC OFF MODE)

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

REPLACE MASTER CYLINDER SOLENOID

TRAC OFF Indicator Light Remains ON

DESCRIPTION The skid control ECU is connected to the combination meter via the CAN communication system. Pressing the VSC OFF switch turns off traction control and pressing and holding this switc ...

VSC OFF Indicator Light does not Come ON

DESCRIPTION Refer to VSC OFF Indicator Light Remains ON (See page ). WIRING DIAGRAM Refer to VSC OFF Indicator Light Remains ON (See page ). CAUTION / NOTICE / HINT NOTICE: When replacing th ...

Other materials about Toyota 4Runner:

Side Step
Components COMPONENTS ILLUSTRATION ILLUSTRATION Disassembly DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE SIDE ST ...

Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver asse ...