DESCRIPTION
Refer to ABS Warning Light Remains ON (See page ).
WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
INSPECT ABS WARNING LIGHT |
(a) Disconnect the A6 skid control ECU connector.
(b) Turn the ignition switch to ON.
(c) Check that the ABS warning light comes on.
OK:
ABS warning light comes on.
OK |
REPLACE MASTER CYLINDER SOLENOID |
|
2. |
CHECK CAN COMMUNICATION LINE |
(a) Turn the ignition switch off.
(b) Connect the A6 skid control ECU connector.
(c) Connect the Techstream to the DLC3.
(d) Turn the ignition switch to ON.
(e) Turn the Techstream on.
(f) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page ).
OK:
CAN Bus Check indicates no malfunctions in CAN communication.
NG |
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
3. |
READ VALUE USING TECHSTREAM (ABS WARNING LIGHT) |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
Rocker Panel Moulding(w/ Intuitive Parking Assist System)
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL NO. 6 ROCKER PA ...
Emission inspection and maintenance (I/M) programs
Some states have vehicle emission inspection programs which include OBD
(On Board Diagnostics) checks. The OBD system monitors the operation of the
emission control system.
If the malfunction indicator lamp comes on
The OBD system determines that a prob ...