DESCRIPTION
This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. |
READ VALUE USING TECHSTREAM (IGNITION SWITCH) |
(a) Using the Techstream, read the Data List (See page ).
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
ACC SW |
Ignition switch ACC signal / ON or OFF |
ON: Ignition switch ACC OFF: Ignition switch off |
- |
OK:
Normal conditions listed above are displayed.
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
2. |
CHECK HARNESS AND CONNECTOR (BATTERY - MAIN BODY ECU) |
(a) Remove the main body ECU (See page ). |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
A-29 (ACC) - Body ground |
Ignition switch ACC |
11 to 14 V |
*a |
Front view of wire harness connector (to Main Body ECU) |
OK |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Lost Communication with ECM (U0100,U0142,U0155)
DESCRIPTION
The air conditioning amplifier communicates with the ECM, main body ECU (multiplex
network body ECU) and combination meter through the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
...
Child restraint systems with a top tether strap
Secure the child restraint system using a seat belt or the lower anchors, and
remove the head restraint.
Open the anchor bracket cover, latch the hook onto the anchor bracket and
tighten the top tether strap.
Make sure the top tether strap is securel ...