The daytime brightness of the accessory meter can be adjusted.
Turn the headlight switch off.
Press and hold the “MODE/
” button.
Press the “MODE/
” or “SET/
” button.
Vehicles without Multi-terrain Select
Vehicles with Multi-terrain Select
Press and hold the “SET/
” button.
When the average fuel consumption is reset
The average fuel consumption displayed on the instrument cluster and “Past Record” screen of the Display Audio system (if equipped) or the navigation system (if equipped) will be reset at the same time.
Adjusting the brightness of the accessory meter
• If left idle for approximately 6 seconds or more while adjusting, the display will revert to the trip information display.
• When the parking lights are on, the brightness of the accessory meter can be adjusted only with the instrument panel light control.
• If the “MODE/ ” button is pressed
and held when the accessory meter light control is displayed, the display will
switch to compass calibration.
Liquid crystal display
Small spots or light spots may appear on the display. This phenomenon is characteristic of liquid crystal displays, and there is no problem with continuing to use the display.
NOTICE
The accessory meter at low temperatures
Allow the interior of the vehicle to warm up before using the liquid crystal display.
At extremely low temperatures, the display monitor may respond slowly, and display changes may be delayed.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT DISC
(a) Align the matchmarks and install the front disc.
HINT:
When ...
Acn Call End
ACN CALL END
1. ACN CALL END
This function terminates the ACN (Automatic Collision Notification) to the telematics
provider. After a collision in which the DCM receives a "Collision Detection Signal",
the vehicle will send the emergency call no ...