ACN CALL END
1. ACN CALL END
This function terminates the ACN (Automatic Collision Notification) to the telematics provider. After a collision in which the DCM receives a "Collision Detection Signal", the vehicle will send the emergency call notification to the telematics provider until the ACN call end utility has been run, or the BUB (Back-Up Battery) (if equipped) is depleted. Use the ACN call end utility to stop the ACN call.
HINT:
After the ACN call end utility has been completed, the BUB (Back-Up Battery) must be replaced.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Choose "Telematics" from the System Selection Menu, and then click "Utility".
(d) Click "DCM Service" on the Utility Selection Menu.
(e) Choose "ACN call end" and then click "Next" on the DCM Service Utility.
(f) Follow the instructions on the Techstream.
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
3. REMOVE REA ...
Diagnosis System
DIAGNOSIS SYSTEM
1. BUS CHECK
(a) Select "CAN Bus Check" from "System Select".
2. CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION
(a) The systems (ECUs and sensors) that use CAN communication vary depending
o ...