ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
2. REMOVE UPPER RADIATOR SUPPORT SEAL
3. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
4. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
5. ADJUST HOOD SUB-ASSEMBLY
(a) Adjust the hood position.
(1) Loosen the 4 hinge bolts on the hood sub-assembly. |
|
(2) Move the hood sub-assembly and adjust the clearance between the hood sub-assembly and front fender.
(3) Tighten the 4 hinge bolts on the hood sub-assembly after the adjustment.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(b) Adjust the height of the front end of the hood sub-assembly using the cushion rubbers.
(1) Adjust the cushion rubbers so that the hood sub-assembly and front fender are aligned. HINT: Raise or lower the front end of the hood sub-assembly by turning the 2 cushion rubbers. |
|
(c) Adjust the hood lock.
(1) Loosen the 3 bolts. |
|
(2) Adjust the hood lock assembly and tighten the 3 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(3) Check that the striker can engage with the hood lock assembly smoothly.
6. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
7. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
8. INSTALL UPPER RADIATOR SUPPORT SEAL
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
(a) Attach the 3 claws to install the shift lock control ECU to the transmission
floor shift.
(b) Connect the shift lock solenoid connector to the shift lock control ECU.
2. INSTALL IND ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the fins of the cooler condenser are dirty, clean them with water. Dry
the fins with compressed air.
NOTICE:
Do not damage the fins of the condenser.
(b) If a fin of the cooler ...