Toyota 4Runner manuals

Toyota 4Runner: Air Conditioning Control Panel Circuit

DESCRIPTION

This circuit consists of the heater control assembly and air conditioning amplifier assembly. When the heater control assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.

If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the heater control assembly is operated.

WIRING DIAGRAM


CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (HEATER CONTROL - AIR CONDITIONING AMPLIFIER)

(a) Disconnect the F42 amplifier connector.

(b) Disconnect the F29 control connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

F29-10 (LIN1) - F42-37 (LIN1)

Always

Below 1 Ω

F29-10 (LIN1) - Body ground

Always

10 kΩ or higher


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK HARNESS AND CONNECTOR (HEATER CONTROL - BATTERY AND BODY GROUND)

(a) Disconnect the F29 control connector.


(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Switch Condition

Specified Condition

F29-4 (IG+) - F29-11 (GND)

Ignition switch off

Below 1 V

F29-4 (IG+) - F29-11 (GND)

Ignition switch ON

11 to 14 V

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

F29-11 (GND) - Body ground

Always

Below 1 Ω

Text in Illustration

*a

Front view of wire harness connector

(to Heater Control Assembly)


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

3.

REPLACE HEATER CONTROL ASSEMBLY

(a) Replace the heater control assembly with a new or normally functioning one (See page ).


(b) Operate the heater control assembly to check that it functions properly.

OK:

Heater control assembly operates normally.


OK

END (HEATER CONTROL ASSEMBLY IS FAULTY)


NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

BUS IC Communication Malfunction (B1497/97)
DESCRIPTION The air conditioning harness assembly connects the No. 1 air conditioning amplifier assembly and each servo motor. The No. 1 air conditioning amplifier assembly supplies power and sen ...

Blower Motor Circuit
DESCRIPTION The blower with fan motor sub-assembly operates according to signals from the air conditioning amplifier assembly. The blower with fan motor sub-assembly speed signals are transmitt ...

Other materials about Toyota 4Runner:

Monitor Drive Pattern
MONITOR DRIVE PATTERN 1. TEST MONITOR DRIVE PATTERN FOR ECT CAUTION: Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving. HINT: Performing this drive pattern is one method to simulate ...

Operating the lights and wipers
Headlight switch The headlights can be operated manually or automatically. Turning the end of the lever turns on the lights as follows: Type A 1. The daytime running lights turn on. 2.   The side marker, parking, tail, license plate, daytime r ...

© 2016-2024 | www.to4runner.net

0.0269