Toyota 4Runner manuals

Toyota 4Runner: Air Conditioning Pressure Sensor

Components

COMPONENTS

ILLUSTRATION


On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT NO. 1 PRESSURE SWITCH

(a) Connect a manifold gauge set.


(b) Connect the positive (+) lead from the ohmmeter to terminal 1 and the negative (-) lead to terminal 2.

(c) Measure the resistance between terminals when refrigerant pressure is charged, as shown in the illustration.

If operation is not as specified, replace the pressure switch.

Text in Illustration

*a

Component without harness connected

(No. 1 Pressure Switch)

*b

Low Pressure Side

*c

On (Below 1.0 Ω)

*d

High Pressure Side

*e

Off (10 kΩ or higher)

Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 PRESSURE SWITCH

(a) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the No. 1 pressure switch.

Compressor oil:

ND-OIL 8 or equivalent

(b) Install the O-ring to the No. 1 pressure switch.

(c) Install the No. 1 pressure switch.

Torque:

11 N·m {112 kgf·cm, 8 ft·lbf}

(d) Connect the connector.

2. CHARGE REFRIGERANT


3. WARM UP ENGINE


4. CHECK FOR REFRIGERANT GAS LEAK


5. INSTALL RADIATOR GRILLE

(a) Install the radiator grille (See page ).


6. INSTALL UPPER RADIATOR SUPPORT SEAL


Removal

REMOVAL

PROCEDURE

1. REMOVE UPPER RADIATOR SUPPORT SEAL


2. REMOVE RADIATOR GRILLE

(a) Remove the radiator grille (See page ).


3. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


4. REMOVE NO. 1 PRESSURE SWITCH


(a) Disconnect the connector.

(b) Remove the No. 1 pressure switch.

(c) Remove the O-ring from the No. 1 pressure switch.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.

Air Conditioning Panel
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL HEATER CONTROL ASSEMBLY (a) Attach the 4 clips to install the heater control assembly. ...

Air Conditioning System(for Automatic Air Conditioning System)
...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. FIX REAR DIFFERENTIAL CARRIER ASSEMBLY IN PLACE (a) Fix the rear differential carrier assembly to the overhaul attachment. 2. INSPECT REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY REAR (a) Using a dial indicator, measure the ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System DTC Code Detection Item See page B1532 LVDS Signal Malfunction (from Extension Module) B1551 HD Radio Tuner ...

© 2016-2024 | www.to4runner.net

0.0249