Toyota 4Runner: Ambient Temperature Sensor

Toyota 4Runner Service Manual / Vehicle Interior / Heating / Air Conditioning / Ambient Temperature Sensor

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	10°C (50°F)	3.00 to 3.73 kΩ
	15°C (59°F)	2.45 to 2.88 kΩ
	20°C (68°F)	1.95 to 2.30 kΩ
	25°C (77°F)	1.60 to 1.80 kΩ
	30°C (86°F)	1.28 to 1.47 kΩ
	35°C (95°F)	1.00 to 1.22 kΩ
	40°C (104°F)	0.80 to 1.00 kΩ
	45°C (113°F)	0.65 to 0.85 kΩ
	50°C (122°F)	0.50 to 0.70 kΩ
	55°C (131°F)	0.44 to 0.60 kΩ
	60°C (140°F)	0.36 to 0.50 kΩ

HINT:

As the temperature increases, the resistance decreases (refer to the graph).

NOTICE:

Touching the sensor even slightly may change the resistance value. Hold the connector of the sensor.

When measuring the resistance, make sure the sensor temperature is the same as the ambient temperature.

If the result is not as specified, replace the cooler thermistor (ambient temperature sensor).

Text in Illustration

*a	Component without harness connected (Ambient Temperature Sensor)
*b	Sensor Area
*c	Resistance (kΩ)
*d	Temperature (°C(°F))

Installation

INSTALLATION

PROCEDURE

1. INSTALL COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)

(a) Attach the clamp to install the sensor.

(b) Connect the connector.

2. INSTALL RADIATOR GRILLE

(a) Install the radiator grille (See page ).

3. INSTALL UPPER RADIATOR SUPPORT SEAL

Removal

REMOVAL

PROCEDURE

1. REMOVE UPPER RADIATOR SUPPORT SEAL

2. REMOVE RADIATOR GRILLE

(a) Remove the radiator grille (See page ).

3. REMOVE COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)

(a) Disconnect the connector.

(b) Using a screwdriver, detach the clamp and remove the sensor.

HINT:

Tape the screwdriver tip before use.

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 1 COOLER THERMISTOR NOTICE: If reusing the evaporator, do not insert the thermistor into a location where the thermistor was previously inserted. (a) Inser ...

Blower Unit

Components COMPONENTS ILLUSTRATION ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT (a) Remove the air conditioning unit (See page ). 2. REMOVE BLOWER ASSEMBLY ...

Other materials about Toyota 4Runner:

Front Seat Inner Belt Assembly
Components COMPONENTS ILLUSTRATION ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL FRON ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...