DESCRIPTION
The AUTO LSD does not operate even if the VSC OFF switch is pressed under the following conditions:
WIRING DIAGRAM
Refer to AUTO LSD Indicator Light Remains ON (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
CHECK CAN COMMUNICATION LINE |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page ).
OK:
CAN Bus Check indicates no malfunctions in CAN communication.
NG |
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
2. |
INSPECT VSC OFF SWITCH |
NG |
REPLACE VSC OFF SWITCH |
|
3. |
CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
4. |
READ VALUE USING TECHSTREAM (AUTO LSD INDICATOR LIGHT) |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
Air Outlet Damper Control Servo Motor Circuit (B1443)
DESCRIPTION
The damper servo sub-assembly (mode damper servo) sends pulse signals to inform
the No. 1 air conditioning amplifier assembly of the damper position. The No. 1
air conditioning amplifier assembly activates the motor (normal or reverse) based
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL REFRESHING SEAT SWITCH
(a) Attach the 4 claws to install the refreshing seat switch.
2. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
3. INSTALL NO. 2 CONSOLE BOX RETAINER
4. INSTALL UPPER CONSO ...