The following functions can be set or canceled:
Setting and canceling the functions
To switch between setting and canceling, follow the procedure below:
Vehicles without a smart key system
Close all the doors and turn the engine switch to the “ON” position. (Perform step 2 within 20 seconds.)
Vehicles with a smart key system
Close all the doors and turn the “ENGINE START STOP” switch to IGNITION ON mode. (Perform step 2 within 20 seconds.)
Shift the shift lever to P or N, and press and hold the driver's door lock
switch ( or
) for approximately 5 seconds and
then release.
The shift lever and switch positions corresponding to the desired function to be set are shown in the following table.
Use the same procedure to cancel the function.
When the setting or canceling operation is complete, all the doors are locked and then unlocked.
Using the mechanical key (vehicles with a smart key system)
The doors can also be locked and unlocked with the mechanical key.
Customization that can be configured at Toyota dealer
Settings (e.g. door unlocking function) can be changed.
(Customizable features )
CAUTION
To prevent an accident
Observe the following precautions while driving the vehicle.
Failure to do so may result in a door opening and an occupant falling out, resulting in death or serious injury.
• Always use a seat belt.
• Always lock all the doors.
• Ensure that all doors are properly closed before driving.
• Do not pull the inside handle of the doors while driving.
The doors may be opened and the passengers are thrown out of the vehicle and it may result in death or serious injury.
Be especially careful for the front doors, as the doors may be opened even if the inside lock buttons are in locked position.
• Set the rear door child-protector locks when children are seated in the rear
seats.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE COOLER BRACKET
(a) Detach the clamp.
(b) Remove the screw and cooler bracket.
2. REMOVE MAGNET CLUTCH ASSEMBLY
(a) Clamp the cooler compressor in a vise.
(b) Using SST, hold the magnet clutch hub.
SST: 07112-76060
( ...
Locking the doors from the outside without a key
Move the inside lock button to
the lock position.
Close the door.
Vehicles without a smart key system
The door cannot be locked if either of the front doors is open and the key is
in the engine switch.
Vehicles with a smart key system
The door can ...