Toyota 4Runner: Back Door Belt Moulding

Speed Signal Circuit

DESCRIPTION The vehicle speed signal consists of pulses sent to the side auto step controller ECU assembly from the main body ECU (multiplex network body ECU). WIRING DIAGRAM PROCEDURE ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat li ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU) (a) Disconnect the S10 sliding roof drive gear sub-assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure ...