DESCRIPTION
The power window regulator motor is driven by operating the back door power window regulator switch. The power window regulator motor assembly has a motor and ECU.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.
HINT:
This DTC may be stored for all the windows.
NOTICE:
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B2313 |
Either condition is met:
|
Back door power window regulator motor |
PROCEDURE
1. |
PERFORM INITIALIZATION (APPLICABLE LOCATION) |
(a) Initialize the power window regulator motor (See page ).
|
2. |
CHECK DTC |
(a) Clear the DTC (See page ).
(b) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
No DTCs output |
A |
DTC B2313 is output |
B |
A |
END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED) |
B |
REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt
chart (See page ).
PROC ...
Installation with LATCH system (rear/second row seats only)
Installing on the rear seats (vehicles without third row seats)
Fold the seatback while pulling the seatback angle adjustment lever. Return
the seatback and secure it at the first lock position.
Type A
Latch the hooks of the lower straps onto the LATC ...