Toyota 4Runner: Back Sonar Sensor LH Circuit

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Park Assist / Monitoring / Intuitive Parking Assist System / Back Sonar Sensor LH Circuit

DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.

WIRING DIAGRAM

PROCEDURE

1.	INSPECT NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR LH)

(a) Remove the No. 1 ultrasonic sensor (rear center sensor LH) (See page ).

(b) Inspect the No. 1 ultrasonic sensor (rear center sensor LH) (See page ).

REPLACE NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR LH)

2.	CHECK HARNESS AND CONNECTOR (REAR CENTER SENSOR LH - CLEARANCE WARNING ECU ASSEMBLY)

(a) Disconnect the P3 No. 1 ultrasonic sensor (rear center sensor LH) connector.

(b) Disconnect the F95 clearance warning ECU assembly connector.

Standard Resistance:

Tester Connection	Condition	Specified Condition
P3-1 (E) - F95-15 (E4)	Always	Below 1 Ω
P3-2 (S) - F95-16 (S4)	Always	Below 1 Ω
P3-1 (E) - Body ground	Always	10 kΩ or higher
P3-2 (S) - Body ground	Always	10 kΩ or higher

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Taillight Relay Circuit

DESCRIPTION This is the power source circuit of the clearance warning ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before p ...

Back Sonar Sensor RH Circuit

DESCRIPTION The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and the obstacle, and sends t ...

Other materials about Toyota 4Runner:

Engine Hood Courtesy Switch Circuit
DESCRIPTION The security courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed. WIRING DIAGRAM PROCEDURE 1. READ VALUE USI ...

Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers. Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver asse ...