DESCRIPTION
The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even after the ignition switch is turned off and is used for diagnostic trouble code memory, etc.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY) |
(a) Disconnect the F42 amplifier connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F42-21 (B) - Body ground |
Always |
11 to 14 V |
*a |
Rear view of wire harness connector (to Air Conditioning Amplifier Assembly) |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Antenna location and effective range
Antenna location
1. Antennas outside the cabin
2. Antennas inside the cabin
3. Antenna outside the luggage compartment
Effective range (areas within which the electronic key is detected)
When locking or unlocking the
doors
The system can be opera ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft
assembly.
(b) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
2. INSTALL ...