General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Where necessary, tighten all the parts of the chassis.
(b) Where necessary, tighten all parts of the body.
2. REPLACE AIR CONDITIONING FILTER
(a) Remove the air conditioning filter (See page ).
(b) Visually inspect the surface of the air conditioning filter.
(c) If the air conditioning filter is contaminated with foreign matter, replace it.
3. TIRE ROTATION
4. FINAL INSPECTION
(a) Check the operation of the body parts.
(1) Hood
(2) Front and rear doors
(3) Back door
(4) Seats
(5) Be sure to deliver a clean vehicle. Especially check:
System Diagram
SYSTEM DIAGRAM
Terminal No. (Symbol)
Wire Harness Side
F14
1 (CANH)
CAN communication line (V Bus)
2 (CANL)
CAN communication line (V Bus)
3 (MSS ...
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
Combination meter assembly
Main body ECU (Multiplex network body ECU)
Vehicle speed signal
CAN
...