Toyota 4Runner: Brake
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
|
(a) Using a mirror, check the entire circumference and length of the brake lines and hoses for:
|
|
(b) Check all the clamps for tightness and the connections for leakage.
(c) Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
(d) Check that the lines are installed properly and pass through the center of the grommets.
2. INSPECT BRAKE LININGS, DRUMS, PADS AND DISCS
(a) Check the brake linings and drums of the parking brake.
(b) Check the brake pads and discs.
|
Type |
See Procedure |
|---|---|
|
Front |
|
|
Rear |
|
.gif)
HINT:
- If a squealing or scraping noise is heard from the brake while driving, check the pad wear indicator.
- If there are traces of the indicator contacting the disc rotor, the disc pad should be replaced.
Body
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Where necessary, tighten all the parts of the chassis.
Front axle and suspension
D ...
Chassis
...
Other materials about Toyota 4Runner:
Stop Light Switch
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector from the stop light switch assembly.
...
Slip Indicator Light Remains ON
DESCRIPTION
The slip indicator light blinks during VSC, TRAC, crawl control, multi-terrain
select control or trailer sway control operation. When the system fails, the slip
indicator light comes on to warn the driver.
WIRING DIAGRAM
CAUTION / NOTICE / ...
0.0246