Toyota 4Runner: Brake System (other)

Yaw Rate And Acceleration Sensor

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the n ...

Brake Booster

...

Other materials about Toyota 4Runner:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT OIL PUMP OIL SEAL (a) Using SST and a hammer, tap in a new oil seal. SST: 09350-30020 09351-32140 HINT: Make sure the oil seal end is flush with the outer edge of the pump body. ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR AXLE SHAFT RH (a) Remove the rear axle shaft RH (See page ). 2. REMOVE REAR AXLE SHAFT LH HINT: Use the same procedure described for the RH side. 3. REMOVE PROPELLER SHAFT ASSEMBLY (a) Remove the propeller shaft asse ...