DESCRIPTION
Refer to Brake Warning Light Remains ON (See page ).
WIRING DIAGRAM
Refer to Brake Warning Light Remains ON (See page ).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
CHECK CAN COMMUNICATION LINE |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page ).
OK:
CAN Bus Check indicates no malfunctions in CAN communication.
NG |
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
2. |
READ VALUE USING TECHSTREAM (BRAKE WARNING LIGHT) |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
Relay(w/ Ptc Heater)
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE PTC HEATER RELAY (PTC NO. 1, PTC NO. 1, PTC NO. 3)
(a) Remove the 3 PTC heater relays from the engine room relay block.
Text in Illustration
*1
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Attach the claw to install the occupant classification ECU.
NOTICE:
If the occupant classification ECU has been dropped, or there are any
cracks, dents or other defects i ...