CALIBRATION
Initial Calibration of Compass:
The compass indicates the direction that the vehicle is heading by detecting the direction and strength of the earth's magnetic field and processing this data using the compass sensor and microcomputer. Detection of the direction and strength of the earth's magnetic field varies according to the area in which the vehicle is used and is affected by the residual magnetism of the vehicle. For this reason, the geographic direction displayed may also deviate from the direction determined by the earth's magnetic field according to the area in which the vehicle is used. Therefore, perform the initial calibration of the compass prior to delivery to customers.
1. CIRCLING CALIBRATION PROCEDURE
(a) Start the engine and push the "MODE" button for more than a few seconds.
(b) Drive the vehicle slowly at 8 km/h (5 mph) or less in a circle. If there is not enough space to drive in a circle, turn the car around in the following manner, doing two three-point turns in succession. After driving in 1 to 3 circles in the above method, calibration is completed when the direction is shown on the display.
HINT:
Amplifier Antenna
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF HEADLINING ASSEMBLY
(See page )
2. REMOVE AMPLIFIER ANTENNA ASSEMBLY
(a) Disconnect the 3 connectors.
( ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH
(a) Compress and extend the shock absorber rod and check that there is no abnormal
resistance or unusual sound during operation.
If there is any abnormality, replace the front shock absorbe ...