Toyota 4Runner: CD cannot be Ejected

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Audio / Video / Audio And Visual System / CD cannot be Ejected

PROCEDURE

1.	CHECK OPERATION

(a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected.

OK:

CD is ejected.

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.	REPLACE CD AND RECHECK

(a) Replace the CD with a known good one and check that the malfunction disappears.

OK:

CD is ejected.

CD WAS FAULTY

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

Sound Quality is Bad Only when CD is Played (Volume is Too Low)

PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK ...

CD cannot be Inserted / Played or CD is Ejected Right After Insertion

PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, st ...

Other materials about Toyota 4Runner:

Open in Pump Motor Circuit (C1251)
DESCRIPTION The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU. DTC Code DTC Detection Condition Trouble Area ...

Torque Converter Clutch And Drive Plate
Inspection INSPECTION PROCEDURE 1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY (a) Inspect the 1-way clutch. (1) Install SST to the inner race of the 1-way clutch. SST: 09350-32014 09351-32020 (2) Press on the serrations of the starter with a finger a ...