PROCEDURE
1. |
CHECK CD |
(a) Check that the CD is not deformed or cracked. OK: No deformation or cracks on the CD |
|
NG |
CD IS FAULTY |
|
2. |
CHECK CD |
(a) Check the CD. OK: The CD is clean. NOTICE: Do not use a conventional record cleaner or anti-static preservative. HINT: If dirt is on the CD surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. |
|
NG |
CLEAN CD |
|
3. |
REPLACE CD AND RECHECK |
(a) Replace the CD with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK |
CD WAS FAULTY |
|
4. |
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
(a) Check the radio and display receiver assembly installation condition.
(1) Check that the radio and display receiver assembly is properly installed.
OK:
The radio and display receiver assembly is properly installed.
OK |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG |
REINSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY PROPERLY |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL POWER LIFT STEP ASSEMBLY
(a) Install the power lift step assembly with the 2 ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(a) Install a new O-ring to the brake master cylinder sub-assembly.
(b) Install the brake master cylinder sub-assembly with 2 nuts.
Torque:
13 N·m {127 kgf·c ...