CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
PROCEDURE
1. |
CHECK DISC |
(a) Check that the disc is not deformed or cracked. OK: No deformation or cracks on the disc |
|
NG |
END (DISC IS FAULTY) |
|
2. |
CHECK DISC |
(a) Check the disc. OK: The disc is clean. NOTICE: Do not use a conventional record cleaner or anti-static preservative. HINT: If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction. |
|
NG |
CLEAN DISC |
|
3. |
REPLACE DISC AND RECHECK |
(a) Replace the disc with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK |
END (DISC WAS FAULTY) |
|
4. |
CHECK NAVIGATION RECEIVER ASSEMBLY |
(a) Check the navigation receiver assembly installation condition.
(1) Check that the navigation receiver assembly is properly installed.
OK:
Navigation receiver assembly is properly installed.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
REINSTALL NAVIGATION RECEIVER ASSEMBLY |
Master Cylinder Pressure Sensor Zero Point High Malfunction (C1422)
DESCRIPTION
Refer to DTCs C1421, C1423 and C1424 (See page
).
DTC Code
DTC Detection Condition
Trouble Area
C1422
When the stop light switch assembly is off, the PM/C1 terminal voltage
is 0.8 ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
2. REMOVE UPPER RADIATOR SUPPORT SEAL
3. REMOVE FRONT FENDER MAI ...