Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform a diagnostic system check (See page ).
2. CHECK AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
(a) Perform a diagnostic system check (See page ).
3. CHECK AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS DEPLOYED)
(a) Replace the airbag sensor.
CAUTION:
For removal and installation of the airbag sensor, be sure to follow the correct procedure.
HINT:
The airbag sensor should be replaced after any of the airbags has deployed, as it has been subjected to an impact.
Installation
INSTALLATION
PROCEDURE
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
(c) Install the airbag sensor with the 3 bolts.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
NOTICE:
(d) Check that the airbag sensor is not loose.
(e) Connect the connector.
2. INSTALL REAR CONSOLE BOX ASSEMBLY
(a) Install the rear console box assembly (See page ).
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
4. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE REAR CONSOLE BOX ASSEMBLY
(a) Remove the rear console box sub-assembly (See page ).
3. REMOVE AIRBAG SENSOR ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the 3 bolts and airbag sensor.
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
2. DRAIN BRAKE FLUID
NOTICE:
Wash off the brake fluid immediately if ...
XM Tuner Malfunction (B15BA)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the stereo component tuner
assembly.
DTC Code
DTC Detection Condition
Trouble Area
B15BA
When either of the conditions below is met: ...