CHECK MODE PROCEDURE
NOTICE:
Enter "Signal Check" from the "DTC Check" screen displayed on the Techstream to clear the output DTCs (both present and past).
HINT:
1. CHECK MODE PROCEDURE (Using the Techstream)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Select "Signal Check" and proceed with checking using the Techstream.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FRONT UNIVERSAL JOINT SPIDER BEARING
HINT:
Use the same procedure for all front propeller shaft universal joint spider bearing.
(a) Place matchmarks on the flange yoke and sleeve yoke.
Text in Illustration
...
Transmission Fluid Temperature Sensor "A" Performance (P0711)
DESCRIPTION
The ATF (Automatic Transmission Fluid) temperature sensor converts the ATF temperature
into a resistance value which is input into the ECM.
The ECM applies a voltage to the temperature sensor through ECM terminal THO1.
The sensor resistance ch ...