DESCRIPTION
The clearance warning buzzer sounds to alert the driver. The sounding pattern changes depending on the distance to an obstacle.
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - NO. 1 CLEARANCE WARNING BUZZER) |
(a) Disconnect the F95 clearance warning ECU assembly connector.
(b) Disconnect the F97 No. 1 clearance warning buzzer connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F95-19 (CBZ) - F97-1 (Z+) |
Always |
Below 1 Ω |
F95-20 (FF) - F97-2 (Z-) |
Always |
Below 1 Ω |
F95-19 (CBZ) - Body ground |
Always |
10 kΩ or higher |
F95-20 (FF) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
CHECK NO. 1 CLEARANCE WARNING BUZZER |
(a) Temporarily replace the No. 1 clearance warning buzzer with a new or normally functioning one (See page ).
(b) Check that the clearance warning buzzer sounds properly when the intuitive parking assist system detects an obstacle.
OK:
Buzzer sounds properly.
OK |
END (NO. 1 CLEARANCE SONAR BUZZER IS DEFECTIVE) |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Four-wheel drive system (part-time 4WD models)
Use the front-wheel drive control lever or switch to select the following
transfer modes:
Type A
The four-wheel drive indicator comes on when H4, N or L4 mode is selected.
1. H2 (high speed position, two-wheel drive)
Use this for normal driving on dry ...
Trailer towing tips
Your vehicle will handle differently when towing a trailer. Help to avoid an
accident, death or serious injury, keep the following in mind when towing:
• Speed limits for towing a trailer vary by state or province. Do not exceed
the posted towing speed ...