Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE NO. 2 SWITCH HOLE BASE
3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
(a) Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
(b) Place protective tape as shown in the illustration. Text in Illustration
|
|
(c) Detach the 4 claws.
(d) Detach the 7 clips and remove the finish panel. |
|
5. REMOVE COMBINATION METER ASSEMBLY
(a) Remove the 4 screws. |
|
(b) Disconnect the connectors and remove the combination meter by pulling it up in the direction of the arrow in the illustration.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE COMBINATION METER GLASS
(a) Detach the 10 claws and remove the meter glass. |
|
2. REMOVE NO. 1 COMBINATION METER COVER
(a) Detach the 10 claws and remove the cover. |
|
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 1 COMBINATION METER COVER
(a) Attach the 10 claws to install the cover.
2. INSTALL COMBINATION METER GLASS
(a) Attach the 10 claws to install the meter glass.
Installation
INSTALLATION
PROCEDURE
1. INSTALL COMBINATION METER ASSEMBLY
(a) Connect the connectors.
(b) Install the combination meter with the 4 screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
(a) Attach the 7 claws to install the finish panel.
(b) Attach the 4 claws.
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
4. INSTALL NO. 2 SWITCH HOLE BASE
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
ID BOX EEPROM Malfunction (B2790)
DESCRIPTION
This DTC is stored when the ID code box detects an internal malfunction.
DTC Code
DTC Detection Condition
Trouble Area
B2790
The ID code box detects an internal malfunction.
...
Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external
device to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier
assembly, and then ...