Toyota 4Runner: Components

Vane Pump

...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DRIVE BELT (a) Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. HINT: Cracks on the rib s ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart (See page ). PROCEDURE 1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH (a) Install the front bumper bracket sub-assembly LH with the 2 ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE LOWER FRONT BUMPER COVER (w/ KDSS) 3. REMOVE NO. 1 ENGINE ...