Toyota 4Runner: Components

Steering Gear

...

Removal

REMOVAL PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. REMOVE FRONT WHEELS 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE REAR ENGINE UNDER COVER ASSEMBLY Clic ...

Other materials about Toyota 4Runner:

Power Supply Drive Circuit (C1257)
DESCRIPTION The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU. DTC Code DTC Detection Condition Trouble Area ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is shown in the standard bolt chart (See page ). PROC ...