Toyota 4Runner: Components

Sliding Roof Housing

...

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STOP LIGHT CONTROL RELAY (a) Remove the stop light control relay from the engine room relay block. (b) Measure the resistance according to the value(s) in the table below. Stan ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY (a) Remove the rear No. 2 seat assembly (See page ). 2. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Deck Board) 3. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board) 4. REMOVE NO. 2 LUG ...