Toyota 4Runner: Components

Knee Airbag Assembly(for Driver Side)

...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CHECK LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). (b) With the lower ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all rear propeller shaft universal joint spider bearing. (a) Place matchmarks on the flange yoke and propeller shaft. Text i ...

Initialization
INITIALIZATION 1. ZERO POINT CALIBRATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform the zero point calibration and sensitivity check if any of the following conditions apply. ...