CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)
HINT:
The following items can be customized.
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Customize.
(e) Select the setting by referring to the table below.
Wiper|
Display |
Default |
Content |
Setting |
|---|---|---|---|
|
Linked Rear Wiper Washer |
AVAIL |
Function to make the rear wiper run automatically after the washer function is used. |
NOT AVAIL or AVAIL |
|
Rewipe Function |
AVAIL |
Function to make the rear wiper run once automatically for a certain amount of time after the washer function is completed to prevent the dripping of washing fluid. |
NOT AVAIL or AVAIL |
|
Rear Wiper Interval Speed |
3 sec. |
Function used to change the time from when the rear wiper stops moving until it starts moving again in intermittent mode. |
3 sec., 2 sec., 4 sec. or 5 sec. |
|
Rear Wiper Retract Time |
3 sec. |
Function used to change the time from when the rear wiper stops moving after the rear wiper switch is turned off until the rear wiper is stored in the spoiler. |
3 sec., 4 sec., 5 sec. or 6 sec. |
How To Proceed With Troubleshooting
Problem Symptoms TableOperation Check
OPERATION CHECK
1. CHECK AUTOMATIC RUNNING BOARD OPERATION
(a) When side auto step switch assembly is "AUTO", the operation and condition
of this control are described below.
Check that the driver side automatic running board operates as follows ...
Steering Knuckle(for 2wd)
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM ...