CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Customize.
(e) Select the setting by referring to the table below.
Wireless Door Lock
Display (item) |
Default |
Function |
Setting |
---|---|---|---|
Wireless Control |
ON |
The function that turns the wireless door lock on or off. |
ON or OFF |
Hazard Answer Back |
ON |
When the lock switch on the transmitter is pressed, this function illuminates the hazard warning lights and side turn signal lights once. When the unlock switch is pressed, the hazard warning lights and side turn signal lights illuminate twice. |
ON or OFF |
Open Door Warning |
ON |
If a door is not completely closed and the transmitter lock switch is pressed, this function makes the buzzer sound for 5 seconds. |
ON or OFF |
Panic Function |
ON |
The function to operate the theft deterrent system by continuously pressing the panic switch on the transmitter for 0.8 seconds. |
ON or OFF |
Auto Lock Time |
60 s |
The function that changes the time until relocking after unlocking the doors with the wireless door lock function. |
30 s, 60 s or 120 s |
Wireless Auto Lock |
ON |
This function turns the wireless auto lock function on or off. |
ON or OFF |
Wireless Buzzer Resp |
ON |
This function turns the wireless door lock buzzer response on or off. |
ON or OFF |
P/W Ope buzzer |
ON |
This function turns the wireless power window buzzer response on or off. |
ON or OFF |
Wireless Buzzer Vol |
Level7 |
This function changes the wireless door lock buzzer volume. |
Level7, Level6, Level5, Level4, Level3, Level2, Level1 or Level0 |
Dtc Check / Clear
DTC CHECK / CLEAR
HINT:
When using the Techstream with the ignition switch off to troubleshoot:
Connect the Techstream to the vehicle and turn the front door courtesy light
switch LH on and off at 1.5 second intervals until communication betw ...
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
1.
CHECK AUDIO SETTINGS
(a) Set "Treble", "Mid" and "Bass" to the initial values and check that sound
is normal.
OK:
Malfunction disappears.
HINT:
Sound quality adjustment measure ...