DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
(a) Disconnect the G40 navigation receiver assembly connector. |
|
(b) Disconnect the G53 No. 1 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
G40-2 (US1-) - G53-2 (UDO-) |
Always |
Below 1 Ω |
G40-3 (US1+) - G53-3 (UDO+) |
Always |
Below 1 Ω |
G40-5 (USG1) - G53-5 (UJSS) |
Always |
Below 1 Ω |
G40-2 (US1-) - Body ground |
Always |
10 kΩ or higher |
G40-3 (US1+) - Body ground |
Always |
10 kΩ or higher |
G40-5 (USG1) - Body ground |
Always |
10 kΩ or higher |
*a |
Front view of wire harness connector (to Navigation Receiver Assembly) |
*b |
Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Steering Angle Sensor Zero Point Malfunction (C1290)
DESCRIPTION
The skid control ECU acquires steering angle sensor zero point every time the
ignition switch is turned to ON and the vehicle is driven at 40 km/h (25 mph) or
more for approximately 10 seconds. The ECU also stores the previous zero point.
If ...
Transponder Key Amplifier
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT TRANSPONDER KEY AMPLIFIER
(a) Apply battery voltage to the connector and check the LED illumination
condition.
OK:
Measurement Con ...