DESCRIPTION
The stereo component tuner assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY) |
(a) Disconnect the s5 and t3 radio and display receiver assembly connectors.
(b) Disconnect the s2 and t2 stereo component tuner assembly connectors.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
s5-1 (USV4) - s2-1 (USV4) |
Always |
Below 1 Ω |
s5-2 (US4-) - s2-2 (US4-) |
Always |
Below 1 Ω |
s5-3 (US4+) - s2-3 (US4+) |
Always |
Below 1 Ω |
s5-4 (UGD4) - s2-4 (UGD4) |
Always |
Below 1 Ω |
s5-5 (USG4) - s2-5 (USG4) |
Always |
Below 1 Ω |
t3-4 (+B2) - t2-4 (+B2) |
Always |
Below 1 Ω |
t3-3 (ACC2) - t2-3 (ACC2) |
Always |
Below 1 Ω |
t3-8 (GND2) - t2-8 (GND2) |
Always |
Below 1 Ω |
s5-1 (USV4) - Body ground |
Always |
10 kΩ or higher |
s5-2 (US4-) - Body ground |
Always |
10 kΩ or higher |
s5-3 (US4+) - Body ground |
Always |
10 kΩ or higher |
s5-4 (UGD4) - Body ground |
Always |
10 kΩ or higher |
s5-5 (USG4) - Body ground |
Always |
10 kΩ or higher |
t3-4 (+B2) - Body ground |
Always |
10 kΩ or higher |
t3-3 (ACC2) - Body ground |
Always |
10 kΩ or higher |
t3-8 (GND2) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS AND CONNECTOR |
|
2. |
REPLACE NO. 1 NAVIGATION WIRE |
(a) Replace the No. 1 navigation wire (See page ).
(b) Check that the malfunction disappears.
OK:
Malfunction disappears.
OK |
END (NO. 1 NAVIGATION WIRE IS DEFECTIVE) |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Installation
INSTALLATION
PROCEDURE
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the switch to the manual valve shaft.
(b) Temporarily install the bolt.
(c) Install a new lock washer and the nut ...
Automatic Disconnecting Differential Actuator
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR
(a) Remove any old FIPG material.
NOTICE:
Be careful not to drop oil on the contact surfaces of the actuator and clut ...