Toyota 4Runner: Deactivating the curtain shield airbags in a vehicle rollover

Toyota 4Runner Owners Manual / Before driving / Safety information / SRS airbags / Deactivating the curtain shield airbags in a vehicle rollover

On/off (hold for a few seconds)

Vehicles without a smart key system: The “RSCA OFF” indicator turns on. (only when the engine switch is in the “ON” position).

The roll sensing function for the curtain shield airbags and seat belt pretensioners will turn back on automatically each time the engine switch is turned to the “ON” position.

Vehicles with a smart key system: The “RSCA OFF” indicator comes on. (only when the “ENGINE START STOP” switch is in IGNITION ON mode).

The roll sensing function for the curtain shield airbags and seat belt pretensioners will turn back on automatically each time the “ENGINE START STOP” switch is turned to IGNITION ON mode.

This switch only should be used

In a situation where the inflation is not desired (such as during extreme offroad driving).

Operating conditions when the “RSCA OFF” indicator is illuminated

• The curtain shield airbags and seat belt pretensioner will not activate in a vehicle rollover.

• The curtain shield airbags will activate in a severe side impact.

• The seat belt pretensioner will activate in a severe frontal or side collision.

CAUTION

During normal driving

Make sure the “RSCA OFF” indicator light is not turned on. If it is left on, the curtain shield airbags will not activate in the event of an accident, which may cause death or serious injury.

SRS airbag system components

1. Side airbags 2. “AIR BAG ON” and “AIR BAG OFF” indicator lights 3. Curtain shield airbags 4. Front passenger airbag 5. Knee airbags 6. Side and curtain shield airbag sensors 7 ...

Front passenger occupant classification system

Your vehicle is equipped with a front passenger occupant classification system. This system detects the conditions of the front passenger seat and activates or deactivates the devices for the fron ...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT LEVEL WARNING SWITCH ASSEMBLY HINT: The following check should be performed with the windshield washer motor and pump installed to the washer jar. (a) Fill the washer jar with washer fluid. (b) Measure the res ...

Sliding Roof ECU Power Source Circuit
DESCRIPTION If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof drive gear sub-assembly power source circuit. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When the sliding roof drive gear ...