Toyota 4Runner: Diagnosis System
DIAGNOSIS SYSTEM
1. FUNCTION OF AUTOMATIC RUNNING BOARD WARNING LIGHT
(a) When a malfunction is detected in the automatic running board system, the
automatic running board warning light in the combination meter comes on to inform
the driver of the malfunction.
(b) The operation and condition of this control are described below.
Operation
|
Condition
|
Comes on
|
- When the jam protection function has operated.*1
- When the automatic running board is not fully stowed while the
vehicle is moving (at a speed of 8 km/h [5 mph] or more).*2
|
Blinks
|
When a DTC has been output.
|
HINT:
- *1: The automatic running board warning light turns off when the automatic
running board is deployed or stowed normally with the operation of the doors.
Also, the warning light will turn off 20 minutes after it is lit.
- *2: The automatic running board warning light turns off when the automatic
running board is stowed normally. Also, the warning light will turn off
20 minutes after it is lit.
- *3: The automatic running board warning light turns off when the abnormal
state of the automatic running board system is resolved, and the system
returns to a normal state. Also, the warning light will turn off 20 minutes
after it is lit, even if the abnormal state is not resolved.
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
(a) Measure the voltage according to the value(s) in the table below.
Ter ...
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any p ...
Other materials about Toyota 4Runner:
Rear Door LH ECU Communication Stop (B2324)
DESCRIPTION
This DTC is stored when LIN communication between the rear power window regulator
motor assembly LH and main body ECU (multiplex network body ECU) stops for 10 seconds
or more.
DTC Code
DTC Detection Condition
...
Acn Call End
ACN CALL END
1. ACN CALL END
This function terminates the ACN (Automatic Collision Notification) to the telematics
provider. After a collision in which the DCM receives a "Collision Detection Signal",
the vehicle will send the emergency call no ...