DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) Air conditioning system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform troubleshooting.
2. CHECK DLC3
(a) Check the DLC3 (See page ).
3. LIST OF OPERATION METHODS
(a) By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter the diagnostic check mode.
4. INDICATOR CHECK
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ACC and wait at least 5 seconds.
(c) Press and hold the air conditioning control "AUTO" switch and "recirculation/fresh" switch simultaneously, and turn the ignition switch to ON. Continue holding the 2 switches until panel diagnosis mode begins.
(d) Check that all indicators turn on and off 4 times in succession at 1 second intervals.
HINT:
5. DTC CHECK (SENSOR CHECK)
(a) Start the engine and warm it up.
(b) Perform the indicator check.
HINT:
After the indicator check is completed, the system enters DTC check mode automatically.
(c) Read the code displayed on the panel.
NOTICE:
In sensor check mode, which is automatically entered after indicator check mode, troubleshooting may be only partially completed.
HINT:
Refer to the Diagnostic Trouble Code Chart for details of the codes (See page ).
(d) If the codes are difficult to read because they change automatically, operate the driver temperature up switch to display the codes one at a time so that they can be read easily. The items are displayed one by one each time the driver temperature up switch is operated.
HINT:
Push the "OFF" switch to finish panel diagnosis.
Lost Communication with ECM/PCM "A" (U0100/71,U0122/71,U0124/71,U0126/71)
DESCRIPTION
DTC Code
DTC Detection Condition
Trouble Area
U0100/71
While driving at 30 km/h (19 mph), the ECM indicates a CAN communication
stop for 3 seconds or more.
CAN communicati ...
Telephone Microphone
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE DRIVE MONITOR SWITCH
2. REMOVE MAP LIGHT ASSEMBLY
3. REMOVE TELEPHONE MICROPHONE ASSEMBLY
(a) Disconnect the 6 connectors.
...