DIAGNOSTIC TROUBLE CODE CHART
NOTICE:
Turn the ignition switch off before removing parts.
HINT:
DTC Code |
Detection Item |
Trouble Area |
See page |
---|---|---|---|
C1812/12 |
Pressure Sensor Malfunction / Upside |
- Harness or connector - Accumulator pressure sensor (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1831/31 |
Accumulator Solenoid Malfunction / Upside |
- Harness or connector - Stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1832/32 |
Accumulator Solenoid Malfunction / Downside |
- Harness or connector - Stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1851/51 |
Low Pressure Malfunction in Upside of KDSS System |
- Hydraulic circuit - Harness or connector - Accumulator pressure sensor or stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1853/53 |
High Pressure Malfunction in Upside of KDSS System |
- Hydraulic circuit - Harness or connector - Accumulator pressure sensor or stabilizer control solenoid valve (Stabilizer control with accumulator housing assembly) - Stabilizer control ECU |
|
C1879/79 |
Zero Point Calibration of Acceleration Sensor Undone |
- Brake control system (Yaw rate and acceleration sensor zero point calibration) - Stabilizer control ECU |
|
C1881/81 |
KDSS ECU Malfunction |
Stabilizer control ECU |
|
C1882/82 |
Power Supply Voltage Malfunction |
- Battery - Charging system - KDSS fuse - Harness or connector - Stabilizer control ECU |
|
C1883/83 |
Speed Sensor Circuit Malfunction |
- Brake control system - CAN communication system - Stabilizer control ECU |
|
C1884/84 |
Steering Angle Sensor Circuit Malfunction |
- Steering angle sensor (Spiral cable sub-assembly) - CAN communication system - Stabilizer control ECU |
|
C1887/87 |
Acceleration Sensor Circuit Malfunction |
- Yaw rate and acceleration sensor - CAN communication system - Stabilizer control ECU |
|
U0100/71 |
Lost Communication with ECM / PCM "A |
CAN communication system |
|
U0122/71 |
Lost Communication with Vehicle Dynamics Control Module |
CAN communication system |
|
U0124/71 |
Lost Communication with Lateral Acceleration Sensor Module |
CAN communication system |
|
U0126/71 |
Lost Communication with Steering Angle Sensor Module |
CAN communication system |
|
Back Door ECU Communication Stop (B1287)
DESCRIPTION
This DTC is stored when LIN communication between the multiplex network door
ECU (back door P/W) and main body ECU (multiplex network body ECU) stops for 10
seconds or more.
DTC Code
DTC Detection Condition
Tr ...
Rear Combination Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT LEN ...