DESCRIPTION
The skid control ECU measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must indicate the same speed.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1337 |
Either condition is met:
|
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
HINT:
When DTCs C1401 to C1416 are output with DTC C1337, inspect and repair the trouble areas indicated by DTCs C1401 to C1416 first (See page ).
PROCEDURE
1. |
CHECK TIRE SIZE |
(a) Check tire size and condition of all 4 wheels.
OK:
Condition of all 4 wheels is normal and tire size is same.
NG |
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE |
|
2. |
RECONFIRM DTC |
(a) Clear the DTCs (See page ).
(b) Turn the ignition switch off.
(c) Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.
(d) Check if the same DTCs are output (See page ).
HINT:
Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.
Result
Result |
Proceed to |
---|---|
DTC is output |
A |
DTC is not output |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
USE SIMULATION METHOD TO CHECK |
System Description
SYSTEM DESCRIPTION
1. ILLUMINATION CONTROL SYSTEM (Illuminated Entry System)
(a) The illuminated entry system has the following control functions:
Control
Outline
Lighting
Actuation Area-linked*1
...
Operation Check
OPERATION CHECK
1. AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
(a) Turn the ignition switch to ON.
(b) Turn the headlight dimmer switch to the AUTO position.
(c) Cover the automatic light control sensor.
(d) Check that the taillights and low beam headl ...