Toyota 4Runner: Disassembly

Toyota 4Runner Service Manual / Steering / Steering Gear / Linkage / Steering Gear / Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

NOTICE:

When using a vise, do not overtighten it.

PROCEDURE

1. REMOVE TIE ROD END SUB-ASSEMBLY LH

(a) Put matchmarks on the tie rod end LH and steering rack end.

Text in Illustration

*a	Matchmark
*b	Length A

(b) Measure length A and record the measurement.

2. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.

3. REMOVE TURN PRESSURE TUBE

(a) Using a union nut wrench, remove the turn pressure tube LH and RH.

4. REMOVE STEERING GEAR OUTLET RETURN TUBE

(a) Using a union nut wrench, remove the return tube from the steering gear.

5. REMOVE STEERING RACK BOOT CLIP LH

(a) Using pliers, remove the steering rack boot clip.

6. REMOVE STEERING RACK BOOT CLIP RH

HINT:

Use the same procedures described for the LH side.

7. REMOVE STEERING RACK BOOT CLAMP LH

(a) Using pliers, remove the boot clamp as shown in the illustration.

NOTICE:

Be careful not to damage the steering rack boot.

8. REMOVE STEERING RACK BOOT CLAMP RH

HINT:

Use the same procedures described for the LH side.

9. REMOVE NO. 2 STEERING RACK BOOT

(a) Remove the steering rack boot.

10. REMOVE NO. 1 STEERING RACK BOOT

(a) Remove the steering rack boot.

11. SECURE RACK AND PINION POWER STEERING GEAR ASSEMBLY

(a) Using SST, secure the steering gear assembly.

SST: 09612-00012

HINT:

Tape SST before use.

12. REMOVE STEERING RACK END SUB-ASSEMBLY

(a) Using SST, hold the steering rack (LH side).

SST: 09922-10010

Text in Illustration

*A	LH Side
*B	RH Side
*a	Hold
*b	Turn

(b) Using SST, remove the steering rack end (LH side) from the steering rack.

SST: 09922-10010

HINT:

Rotate SST in the direction shown in the illustration.

SST: 09922-10010

HINT:

Rotate SST in the direction shown in the illustration.

NOTICE:

Be sure to rotate SST in the correct direction.
Be sure to keep the steering rack fixed in place with SST.

Removal

REMOVAL PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. REMOVE FRONT WHEELS 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE REAR ENGINE UNDER COVER ASSEMBLY Clic ...

Inspection

INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY (a) Install the nut. (b) Flip the ball joint stud back and forth 5 times as shown in t ...

Other materials about Toyota 4Runner:

Airbag Signal Malfunction/Not Input (B15C4)
DESCRIPTION If the DCM (Telematics Transceiver) detects an error in the communication between the DCM (Telematics Transceiver) and center airbag sensor assembly as a result of the DCM (Telematics Transceiver) self check, this DTC will be set. ...

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in-vehicle device. PROCEDURE 1. CHECK ...